BUTTON

OPERATION [MANUAL mode unless otherwise stipulated]

START

Pump should start if not running.

STOP

Pump should stop if running.

STOP then

MODE

Display shows last five failure records

STOP then

START

Display shows accumulative running time

MODE

SET

[ Parameter 009 set to 00]- Manual to Auto/ Auto to Manual

[ Parameter 009 set to 01]- All buttons locked in Auto mode, To deactivate hold   "MODE" for 5sec.pump will then stop, and controller will switch to manual mode.

To ensure pump and motor is protected it is essential to calibrate the controller parameters as soon

as the pump is running to operational standards. Perform calibration after each installation

or maintenance operation.

START

Parameter calibration:

In Manual mode press“START", give the pump time to run as it would normally then hold "START"(approximately 5-10 sec) or press the“STORE" button (Button on

mainboard with yellow cap). The controller will make a“Di”sound. The controller should now be calibrated to the current spec of the motor.

STOP

Parameter erasing:

Ensure pump has stopped running then hold “STOP” until the controller makes a “Di” sound. (Hold for approximately 5-10 sec). The controller should now be cleared of all calibrations

Main technical characteristics of controller

Control functions

Double liquid level control

Pressure switch control

Temperature control.

Main technical data

Rated output power

Refer to label on controller

Rated input voltage

Refer to label on controller

Liquid level transfer distance

≤200m

Protection function

Dry run

Pump stall

Overload

Open phase

Under/Over voltage

Phase reversal

Main installation data

Working temperature

-25°C – +55°C

Working humidity

20% - 90% Relative Humidity

Degree of protection

IP65

Installation position

Vertical

Unit dimensions (Lx W x H)

330*250*135mm